Skip to main content

20 create a 16 input x 16 output matrix switcher?

Updated

Connection between Master and Slave need to have a direct connection, and not connected through network. Connection is done using a crossover CAT5 cable, connecting both MIMO88s using port LINK BUS and by setting one unit to “MASTER” and the other one to “SLAVE” using the switch on the back panel on each device.

  1. Check the image by clicking here:
  2. Check the image by clicking here:

Connection with the EclerNet is done using the “ETHERNET” port. For EclerNet Manager to detect 16x16 matrix switcher, you have to select “MASTER” MIMO88 device and option. “CONFIG” and change Mode to 16x16

  1. Check the image by clicking here:
  2. Check the image by clicking here:

You can find more details here: